Submitted by dezualy t3_ybqqyf in BuyItForLife
Hornswallower t1_itj7uvk wrote
Reply to comment by DatDan513 in 1956 Frigidaire Range by dezualy
Reading "an exceptionally high voltage (220v)" from a 240v country where the actual voltage is usually hovering around 255v at the outlet...
Dafuq are you low voltage lot on about?
Steeve_Perry t1_itjc3rs wrote
Idk what’s your low frequency ass on about?
Hornswallower t1_itjeyx7 wrote
Cries in 60hz Japan
jared555 t1_itjupjq wrote
Our electric stoves and ovens tend to be 240v too once you get into multiple burners.
F-21 t1_itkz2ks wrote
well, if we're measuring dicks... :)
Ours are often even three phase since three phases are quite common in some parts of Europe. I doubt they're using 380/400V (between phases), cause they also work on 240V, so I assume they route the separate panels to separate phases so they can all draw more current at the same time.
jared555 t1_itl9vyq wrote
Our three phase tends to be 120V/208V when talking about residential and small business which results in things like stoves running slightly cooler due to the lower voltage.
I think for residential they just run two phases to each apartment though.
F-21 t1_itlowv4 wrote
I'm so glad to have industrial three phase power, I have a a bunch of old 'bench' (pedestal) grinders with ~1.5kw motors (2hp), all brushless on three phase power... A big old lathe, three phase drill press, a mill. If I only had a single phase I don't think I could run any of it (maybe with VFD).
Iredditfromwork t1_itjrd38 wrote
Hornswallower t1_itjrx76 wrote
Is this long video trying to explain the concept of 3 phase?
Because we have that too at 415v
TheDisapprovingBrit t1_itkbdqw wrote
What I'm getting us that they can jury rig a 240v connection if they need to, but it doesn't have an earth.
Hornswallower t1_itkdemu wrote
Sketch as.
Thanks though that video was TL;DW
polarbear128 t1_itkk6xk wrote
His vids are always worth a watch if you have the time.
TheDisapprovingBrit t1_itkhdtu wrote
Skip to 7:30 for the relevant bit.
CannadaFarmGuy t1_itkj5j5 wrote
Less than 1000 volts is considered low volts in electrical terms
Hornswallower t1_itkkvof wrote
Depends on application.
500vdc is getting up where it's looking to bite. It'll arc if you're not careful and get too close and grab your hand then bad things are happening.
400vdc is still going to kill you if you touch it, but it isn't trying to jump off the rails and grab you.
Valve amplifiers are fantastic fun but holy shit if some of them aren't scary as shit on the inside.
Viewing a single comment thread. View all comments