Viewing a single comment thread. View all comments

kieppie t1_iusnvcm wrote

Reply to comment by epicmoe in Can anyone tell me why this model of Aga has taps on the front? by epicmoe

Yup - on the old models at least.

Should be fine if left undesturbed.

Same with the lead in the paint

10

Atomicnes t1_iutsqjz wrote

personally i would be willing to deal with modern appliance bullshit to not have to deal with lead and asbestos exposure

4

hazeleyedwolff t1_iuuc9oj wrote

There's not really anything to deal with if the asbestos isn't disturbed and you aren't eating paint chips off it.

4

ol-gormsby t1_iuvfz69 wrote

I bought an old type 2 rayburn for fun, to restore it and use it as a cold-weather party stove.

I was petrified that it had asbestos for insulation. Imagine my relief when I found out asbestos was only used in AGAs, and Rayburns used rockwool.

3

alderhill t1_iuvm54c wrote

I mean, asbestos is pretty nasty as we now understand, but it's more of a long-term exposure danger and really only if it turns into little dusty fibre particles (don't break the insulation!). It's right to be weary, and wear a filter mask if it's exposed, but merely being in its presence inside another item won't harm you.

1

ol-gormsby t1_iuvo2k0 wrote

Well, I had to disassemble the rear of it where the insulation was located.

The previous owners had run it "dry", i.e. run fires in it without the boiler having any water in it, so this beautiful heavy-gauge copper boiler had a great big hole burnt in it, so that had to go. The plan was to replace the boiler with firebricks, so,

  1. the back panel had to come off. I swear it hadn't been unscrewed since it left the factory in the 1950s
  2. the insulation had to come out (this was the scary bit). It was still a bit nasty because it was all kind of decomposed. I think it was originally in sheets, but it came out in handfuls.
  3. the boiler had to come out
  4. I had to measure up the void and cut firebricks to fit (this is also scary, because firebricks need a diamond saw to cut, and you've *got* to keep it all wet because of a. heat, and b. danger of silica dust
  5. fit the bricks and secure them with refractory cement - also a silica dust risk when mixing
  6. apply sheets of rockwool or fibreglass insulation
  7. screw the back panel on
  8. test fire.
  9. damn, it leaks, there is smoke coming out everywhere.

I eventually got it working, though. It's not nearly as efficient as the one in my kitchen, but then there's about 40 years of design and manufacturing improvements between them.

2

alderhill t1_iuvyamp wrote

Man, just reading that gave me the shivers.

1