Ex-maven t1_je9c6ge wrote on March 30, 2023 at 11:05 AM

Reply to comment by Hexabor in Disassembly information for old Wilka cylindrical lock by Hexabor

As kitwashere suggested, did you remove the edge plate and look for 1 or 2 small holes just to one side or both sides of the bolt (the holes would be covered by that plate)? The hole(s), if there, would be very small and hard to notice unless you knew to look for anything there. I think a small hex driver (perhaps ~.063", .078", 2mm...) is typically used to back out the setscrew(s).

Hexabor OP t1_jefspa4 wrote on March 31, 2023 at 6:17 PM

Thank you so much! Finally I wrote Wilka (the lock Trademark) and they send me the original instructions. I'm going to attach it to the post.

Many thanks!

Cheers.

Ex-maven t1_jefu3xy wrote on March 31, 2023 at 6:26 PM

Ah, so that probably explains what those scratches along the groove were about. They match perfectly with the use of a wire tool.

Glad it worked out. Thanks for the update!