bb8c3por2d2 t1_jeatd38 wrote on March 30, 2023 at 5:45 PM

Have you tried to reset the breakers? The drum will run with only 120v, but the heating element needs 220v.

steakhaus OP t1_jeau8kg wrote on March 30, 2023 at 5:50 PM

Thanks. Checked those. It’s an attached double breaker. I did flip them off and back on to double check. No dice.

Adam2013 t1_jeazdtg wrote on March 30, 2023 at 6:23 PM

Check the control board for any blown glass fuses if you aren't getting 220VAC (in the US) between both spade connectors on the new coil

steakhaus OP t1_jebfznu wrote on March 30, 2023 at 8:09 PM

I don’t see any control boards. It’s a pretty old dryer. There looks to be a block where several wires connect on the side of the motor. It’s hard to get to are there fuses there possibly.

Adam2013 t1_jecbcgl wrote on March 30, 2023 at 11:40 PM

Try that, and make sure those connections are tight. Make sure the dryer is unplugged before you tighten

Do you have to a multimeter?

steakhaus OP t1_jed7t7s wrote on March 31, 2023 at 3:57 AM

I do have a multimeter. I checked the thermal fuse and it has continuity. I don’t know anything else to check. Those were the main search results.

Adam2013 t1_jed88pk wrote on March 31, 2023 at 4:01 AM

Check that the heating element has 240 volts across the inputs when the power is on. Be very careful when you're doing this, do not short anything and do not touch anything electrical with your body.