Viewing a single comment thread. View all comments

HornetsnHomebrew OP t1_jde9tty wrote

A good question. It holds the end of the rail. The rail sits on it and doesn’t have a screw-friendly surface to attach it to the back. The flat surface faces the floor and therefore rests on this (cheesy, low cost, minimal, pisses me off) bracket.

1

zedsmith t1_jdea3dc wrote

If you can’t come up with a solution, it would not be the end of the world, imo, to just get a new pair of under mount drawer slides with their corresponding brackets.

1

HornetsnHomebrew OP t1_jdeabfj wrote

Agreed. I’m going to try the Swisco brackets and see if they support these rails. If not, then replacing the whole rail is not the end of the world.

1