Comments

You must log in or register to comment.

KermitMadMan t1_jduxghy wrote

pleased check if it’s load bearing before you remove it

−17

Tobacco_Bhaji t1_jdvkmrn wrote

>If you're not sure whether a wall is load-bearing or not, it's essential to consult with a structural engineer or a licensed contractor before you start any demolition or construction work.

If you're not a structural engineer or similarly qualified person, you aren't sure. You just think you're sure. You need to consult a licensed engineer.

31

pooponacandle t1_jdvyal0 wrote

Yeah not that it’s not good advise for a lot of people, but it gets mentioned every single time someone makes a post about removing a wall, especially if OP says they did check.

I swear it’s just one of the Reddit Pavlov’s now for free karma in this sub

5

ElPadrote t1_jdw7l5t wrote

As if load bearing framing doesn’t look differently than non-load bearing framing. You can identify it with ease - planning a modification is a different story. Our city requires permit and engineer assessment before modifying load bearing walls. Not having that can severely impact the ability to sell your house later on.

1

sysiphean t1_jdwgygi wrote

My office wall is not structural, and I am fully sure without the aid of an engineer. The rafters run parallel to the wall. From the attic I can see the whole top of the plate, the drywall of the ceilings on each side, and the short boards (can’t think of the name) tying the header to the rafters.

There are times where one can absolutely tell without a structural engineer.

4

YurAvgDroidGuy t1_jdx8br1 wrote

Looks good! I took out an entire wall in my kitchen too. A lot of these are common sense. When you go in the basement and determine your kitchen wall above is sitting on 3/4" subfloor between 2 floor joists running parallel with the joists, you know it's not load bearing, call me crazy.

6

LeatherDonkey140 t1_jdxb0j3 wrote

Why don’t you pop your head into the attic(assuming it’s a 1 story) and see if there is any roof bracing/ purlins/posts bearing on that section of wall…that will tell you if it is load bearing….if it is a 2 story…call a SE.

−1

tdotr6 t1_jdzmuui wrote

This was the before picture. Stinks losing the shelving but I think there is no value in making the opening bigger.

This entire post was cringe.. from the amount of effort put into the captions that are just... Poorly written and cringe content.

1

sysiphean t1_je0cy5a wrote

I mean, if you can believe that a wall supporting nothing with nothing above it and nothing below the floor to support it is somehow structural, and want to pay someone to tell you otherwise, be my guest. I just know there’s a point where one can be far-more-than-reasonably sure of a thing and not need to spend money to validate the 0.001% probability.

1

Tobacco_Bhaji t1_je6272j wrote

Your made-up percentages mean very little. My family's life means a great deal.

I'm not willing to let my ego, my small man complex or whatever it is you cowboys are dealing with, put them at risk.

It's pointless thing to do. Your penis does not grow with risk taking.

0