Viewing a single comment thread. View all comments

dominus_aranearum t1_isvm5xa wrote

Reply to comment by DadOfFan in dressing a cutoff wheel by DadOfFan

What angle are you cutting the material at with your grinder? You should be as close to a 90° as possible to minimize the cross section at your cut. Trying to cut much longer areas will cause your problem where cuts seem to take forever.

4

Walty_C t1_isw2j54 wrote

That was my guess, he's pressing or pulling it. Somethings off about his technique.

2

DadOfFan OP t1_isw7885 wrote

Its 90, well as close as the cheap cutoff stand will allow, however that is much greater than doing it by hand.

1