Submitted by ctrlaltd1337 t3_ygttu7 in DIY
No_Carpet7125 t1_iual1ey wrote
If you are filling with plywood, then putting cove around the edges, and then painting all white then I would leave it. It will look fine.
ctrlaltd1337 OP t1_iualyos wrote
Yeah, I'm filling each panel with some hardboard and cove trim, then painting everything white after some filler etc. I'm probably just being overly picky, but I guess if I did slide the vertical over it would make everything pretty damn close to "perfect."
No_Carpet7125 t1_iuamnlp wrote
Thinking about it a bit more, I think if you were to start over the best way would be to let that top diagonal piece run completely to the other side of the vertical piece, mark the angles on both and cut both. Then butt the lower rail against the diagonal rail piece, which is sitting on top of the vertical piece.
Hope that made sense.
ctrlaltd1337 OP t1_iuan3ma wrote
Yeah that does make sense and I agree it's probably the best way, but I brad nailed and liquid nailed the shit out of every piece hahaha.
No_Carpet7125 t1_iuar8z0 wrote
I think it will be fine. Nice work.
Viewing a single comment thread. View all comments