Templar42_ZH t1_iwefecd wrote
Flush cut router bit with a bearing. Either top or bottom mount can work just make sure the bearing rides against the rotten wood to guide. Likely will need to clean up those corners, grab your pull saw for that.
whippets OP t1_iwesn20 wrote
That won’t work sorry if that looks like a big piece but look at the Imgur album that’s the profile of the board, taken from the side edge
Templar42_ZH t1_iwfo0te wrote
All is not lost! Both of these are produced by a router bit. Well, two different bits but still. Due to a combination of beer league hockey and alcohol I am currently unable to find the bits you need. Hopefully someone else will swoop in and take the assist.
Viewing a single comment thread. View all comments