Viewing a single comment thread. View all comments

allicat828 OP t1_iy9tlvb wrote

Reply to comment by SeveralPoopEmojis in Shower renovation - edges of the shower pan are covered up by a thick layer of compound. Not sure how to proceed. Any good resources for non-cookie-cutter renovations? by allicat828

20 years indeed - the hot water knob in the shower wouldn't budge, so you could either taking a hot shower or a scalding hot shower. Had to turn on the sink during the summer.

And I kid you not - after taking the fixtures off in the shower, the hot water that previously fed the toilet turned cold and the sink was no longer scalding right after turning it on. It's been two days and already an adventure.

I was hoping to avoid taking it down to the studs but that honestly might be less work anyway.

11

scotus_canadensis t1_iyadrvl wrote

Any work in a bathroom should be undertaken with the understanding (and willingness) that you might have to gut it.

9

allicat828 OP t1_iyat8jy wrote

Yes, I was hoping to avoid it but I suspected a few leaks and was prepared for the worst. I was originally going to use a contractor, but he's booked for the foreseeable future, and my shower started leaking. So I'm attempting myself - baby steps!

3

mirado_shadar t1_iyayhb3 wrote

Best of luck. I'm afraid I have the same adventure in the bathroom coming my way as well. Check the incoming pressure from the city line. Our local water runs a 2in line into a single family house. Pressure regulators are something the local plumbers mention after a few calls.

3

allicat828 OP t1_iyb2elx wrote

Good to know, thank you! And best of luck to you, too!

1