Submitted by steventual t3_yvdpgz in DIY
steventual OP t1_iwe43cu wrote
Reply to comment by NotWorthTheTimeX in How to mount reducer threshold by steventual
From what I’ve read it’s suggested not to mount to either floating surfaces. So maybe will have to make a 1/4” strip of wood in the middle, nail it down in between and then glue to it. Not sure yet hoping for better ideas
NotWorthTheTimeX t1_iwe4q10 wrote
Why would you limit the floating space between the floors by 50%? I assure you the best way is to glue it to the top of the LVT. Letting both floors float is what’s needed. You have a somewhat rare situation but this is the way to handle it.
steventual OP t1_iwe4w5e wrote
Ok seems the most plausible way so far, I’ll try tomorrow unless anyone has a better idea :)
NotWorthTheTimeX t1_iwe5f2m wrote
Enjoy your new floor. I regularly fix problems like this. It’s really simple if you read the full installation instructions. Respect the expansion gaps and your floor will be great for many years to come.
steventual OP t1_iwe5qny wrote
Thanks! I am doing a few other places in the house, they all have an existing t molding and will need a reducer, what would be the proper way to do it next time? Should I overhang the Lvt tile over the edge to cover the gap? I was worried that it wouldn’t have support under it and may crack on stepping. Or should I do the same thing, leave the gap and glue to the top Lvt?
NotWorthTheTimeX t1_iwe766s wrote
It all depends on what flooring type you’re transitioning to. Assuming they’re all LVT to wood like this, you’re doing it correctly.
Never overhang the LVT over the edge to cover the gap. It needs to be fully supported.
Viewing a single comment thread. View all comments