Comments

You must log in or register to comment.

I_R0M_I t1_ixrypwc wrote

I've seen it done with celotex type stuff. You can get special toggle things to hold it in place, or trays etc.

Also seen a more DIY approach of mesh netting stapled under joists, and rock wool type roll placed on the netting between joists.

8

xenglandx t1_ixs6hna wrote

I was sure they banned it and came here to find out why

5

ZolotoGold t1_ixsihmd wrote

Be careful, you could end up with damp if you block up your cavities with insulation.

3

uncle_escobar t1_ixsxm93 wrote

Hey I did this last year. I used celotex or whatever brand equivalent. I personally found it really easy to cut to size with a knife and then fit in between the joists. It seemed to have the best insulation rating.

I supported it with nails underneath knocked into the joists and then filled the gaps with insulation foam using a foam gun. The broad headed nails were cheaper than the custom supports or knocking in blocks of wood to support them.

Follow these best practices:

https://www.gov.uk/government/publications/insulating-suspended-timber-floors-best-practice

To prevent blocking anything and hopefully avoiding any damp problems in the future! They suggested quite deep insulation, i think i used 100 or 150mm but can't remember, whatever it suggested in that doc.

Hope that helps.

2

hellcat_uk t1_ixshrmu wrote

Breathable membrane to prevent cold air wash over a fibre insulation that is flexible enough to ensure the gaps between the joists are filled.

1

jsm7464 t1_ixsilis wrote

The mesh is affordable and easy to install. Then just install batt insulation.

1

chopsuwe t1_ixt554n wrote

Your submission has been removed for one or more of the following reason(s):

  • Your question does not include the research you've done to find an answer yourself, or why that research didn't answer your question.

This is a basic requirement so others do not spend time repeating your steps. It is not a judgement about your question being "too easy." We're looking for evidence that you've made an attempt yourself.

  • Please do not use /r/DIY as your first stop for questions - we are not Google.

  • Please search Google and /r/DIY to see if your question has been asked before. Check owners manuals, tech support forums or contact the manufacturer.

  • Have you already done some basic research and are still stuck?

  • Please include what research you have done in your question so that others do not repeat your steps.

  • Consider posting your question in the sticky thread at the top of the subreddit.

  • Ask your question in our Discord server in the appropriate channel.

Please read our Full Sub Rules before resubmitting.

If you believe this was a mistake, please message the moderators.

###Do not respond to this comment - you will not receive a response.

0