Viewing a single comment thread. View all comments

asuhayda t1_iy2c3k8 wrote

Hello! I just got a new storm door and looks like I need to add a 1/4" shim for it to fit properly. My issues is this, the storm door requires a 1" wide by 1" deep mounting surface. I thought I could get a piece of screen moulding and cut it to run the length of the door jam, but it's only 3/4" wide, not 1. Would I be able to find any pieces of wood at Home Depot that are 1/4" thick by 1" wide and long enough to run the length of the door jamb (80")? I know they sell wood shims but those are small and not installed along the the whole jam and I worry about cold air leaking in or that it just won't look that good. Anyone have any thoughts?

1

Razkal719 t1_iy2wvkm wrote

I'm assuming the metal frame has an angle profile with holes for screws to go into the door frame at 90 degrees to each other. So some on the face of the frame and some on the inside of the frame. I'd mount the 3/4 screen molding an 1/8 or 1/4 in from the face of the door frame so that the holes in the metal angle line up with the center of the 3/4 molding. Pre-drill your holes or the molding will split. This will leave a small gap in the inside corner but that shouldn't make the metal frame loose or unsupported provided you get good connection from both the face and inside screws. You may want to buy screws for the inside holes that are a 1/4 inch longer so you still get good grip into the wood door frame.

2

asuhayda t1_iy396l0 wrote

Thank you! I just checked it and you're right, the screen moulding will definitely work. And thanks for the tip on buying longer screws!

2