Viewing a single comment thread. View all comments

iRamHer t1_j1t1q1t wrote

I can't tell what's going on here, but "pink insulation", or any fiber/ stranded insulation don't block air. it has r value but you'll still be promoting air exchange. you'll most likely want a foam, whether that's rigid board or spray, or both. there's other ways to block air transfer, but it depends on construction.

I can't tell if that's a dimensional rift, foil, or missing drywall

1

PhilosophySudden8480 OP t1_j1vjd6t wrote

Much appreciated. I'm still not sure why they carved that old drywall out. The gasket on the top of the door is making 90% contact but lets a lot of sunlight in so I'm at a loss on how to block that 1/16th of an inch properly without obstructing the door. I found two large holes leading to outside that I have filled with foam spray. I appreciate you taking a look!

1

iRamHer t1_j1vklz6 wrote

could they have used a clear caulk? if it's passing light and it's a separation, a quality caulk will fix your issue.

I still don't know what I'm lookin at. the pov/depth of pic is weird. but you can always cut back more drywall to place more material, whether that's wood, foam, combination of, more drywall. if you're getting air, it should be patched somehow.

I'm not sure if you're having a building siding issue or door seal issue at this point. it sounds like you're not sure either and it's confusing me so Consider:

if what you're getting here is light through the flap gasket, your door likely needs adjusted. this is usually as simple as [with the door closed] loosening the track brackets on left and right side and pushing the tracks further towards the gap closing it, and making sure nothing rubs excessively, or that you don't go too far pushing the seal out worse. this is assuming your seal is still pliable and positioned correctly to begin with. you may need to get a track grease if it's a significantly tighter fit/ door wear. seals may need replaced.

1

PhilosophySudden8480 OP t1_j1vm5o3 wrote

Definitely didn't use a clear caulk. I'm able to pass a putty knife through to the other side. Yeah I know the pov/depth seems weird but it's just a view from the top of the door. I posted a wider shot for less confusion.

The only air coming out on the top is where the door gasket is not reaching the drywall. I'm 100% sure that the issue is a combination of air coming in through the door as well as the siding of the building.

I'll have to give that adjustment a try. Thanks

1