Viewing a single comment thread. View all comments

1Steelghost1 t1_j2awqws wrote

Please be aware 3d printers are extremely sensitive to temperature change. So please put this at the top of the enclosure or in a way that does not move air across the build plate or hotend.

5

jpence1983 OP t1_j2ay465 wrote

That's a good point! The grow tent I have and these fans are meant to hang from the top of the tent.

3

rtrski t1_j2b5g8x wrote

The printer should have a cover on it for UV protection if nothing else while in use, right? So if anything you're drawing air around the printer but not really over the vat and plate

2

corytheidiot t1_j2e0p1d wrote

You are both talking about different printers. Top comment is FDM and yours is Resin.

1