Viewing a single comment thread. View all comments

bwLearnsProgramming OP t1_j1b78iz wrote

Would the motor being bad explain the lack of voltage at the switch though ? Like it’s shorting in the motor or something ? It is very old fixture.

2

Joecool2008 t1_j1b7nmt wrote

I have limited experience, but depending on the fixture there can be (note can be) a smaller fuse inside the motor that could interrupt the flow. Might find a part number and see if there's a manual running around the internet.

2

Alwayssunnyinarizona t1_j1be8ib wrote

Are you sure you've got the voltmeter set on AC and not DC?

2

bwLearnsProgramming OP t1_j1dg7jq wrote

Yes

1

Alwayssunnyinarizona t1_j1dh1e9 wrote

If it is set on AC, I agree with other posts about something upstream like a tripped breaker. There should be 120V at the switch.

I ask because I often go between testing AC and DC and sometimes forget that I have it set to DC when testing and AC circuit, and vice versa. That low 0.3V is often what reminds me to change it.

2