Viewing a single comment thread. View all comments

SkiVail01 t1_j20mwth wrote

Reply to comment by MisterCanoeHead in Crown moulding — single bevel saw by MisterCanoeHead

You would cut your length and angle with the first cut flat then you'd cut the back bevel cut on the crown against the fence so the miter joint is tight. Sounds easy but depending on your crown profile this could be rather difficult to achieve. Just an fyi

5

MisterCanoeHead OP t1_j20nksl wrote

Got it… I see what you’re saying. I just tried the other methods… having the board top-down at a 45 degree angle against the back fence and cutting on a 45 degree angle. Worked fine for both inside and outside corners so I’ll thick with that method. Thanks for the insight.

3