Submitted by Arkehn t3_1001azi in DIY

Have a 25' x 5' section of concrete slab that I need to remove this adhesive from. I removed engineered wood flooring, and am going to lay LVP. Floor needs to be fairly smooth and level but I'm not worried about stains or imperfections. What (not expensive) chemical/soap/degreaser would most likely help loosen this to scrape up? It is VERY sticky as shown.

https://i.imgur.com/mjx2Aka.jpg

11

Comments

You must log in or register to comment.

Arkehn OP t1_j2ewjbq wrote

Grinding would gum up and/or burn, and there's a lot to remove. Would have to rent a specialty scraping type machine. Would rather spend less and use some elbow grease.

2

wiffleplop t1_j2ex80g wrote

I had some black tarry adhesive left on my floor after removing awful vinyl tiles, and had to chip them off with a hammer and cold chisel. Took a while and left me with a dusty floor, so had to give it a coat of self-leveller.

4

Decon_SaintJohn t1_j2exknj wrote

You can rent or buy a floor scraper with a metal/carbide blade on it. It has a long handle like a shovel, with the flat blade on the end. It should suffice for taking that glue off the cement floor.

2

singlejeff t1_j2f1rea wrote

I’d try some less volatile chemical strippers. I have some orange ‘flavored’ stripper that seemed to work on the tar style adhesive. Get a little bottle to start, try a few methods (maybe cover with plastic wrap to lessen evaporation), before giving up on this method.

1

pseudonominom t1_j2f3h60 wrote

Bean-e-doo

You’re welcome and have a happy new year.

1

bunbeck13 t1_j2fap0q wrote

Try regular cooking oil on a test spot, leave it to soak for 24 hours. You can clean up the oil with blue Dawn.

−2

Rob636 t1_j2fch19 wrote

I’d rent a flooring sander and go to town. Can’t be more than $100 for a day rental

2

spince t1_j2fgal2 wrote

We had the same, but on advice of our contractor had it tested for asbestos. Both the tile and mastic had asbestos and we had to hire a specialized company to remove all of it 🤦

4

upstateduck t1_j2fmxv6 wrote

You could skim coat it with modified thinset

You don't really care how well it adheres as it is just a shim

1