Viewing a single comment thread. View all comments

boopspookthrowaway OP t1_j25xjcw wrote

Update: I used a magnet and it stuck to a spot on each area with masking tape, I'm guessing these are the screws that hold the drywall to the studs? Each piece of masking tape is about 16-18 inches apart, I'll have to double check some of them.

1

PreschoolBoole t1_j25y5xx wrote

I use magnets to find studs, I’ve never had good luck with stud finders. Your stud finder probably uses a magnet or something similar, and where you taped is where the screws are. You can assume the studs run vertically where your tape is.

1

junkdumper t1_j25ykav wrote

Yes, that's very likely what you've found.

It's worth noting that there is often doubled up drywall between suites to improve fire ratings. Or there is sound mitigation products in place. Either can cause a little extra havoc with stud finders. I usually use a small drill bill and just check for S solid wood once I'm 99% sure I've found the studs.

1