Viewing a single comment thread. View all comments

[deleted] t1_j6frm8i wrote

−1

GoodGoodGoody t1_j6fu9jc wrote

Well, I work on a lot of old bikes and have never once needed an angle grinder but I’m sure you’re an expert.

Just like I’m sure

-You won’t have difficulty getting even a small grinder in that tight space

-Op, who based on the question is clearly inexperienced won’t overcut into the relatively soft and thin frame, and that kickstand area is where three structural members join (actually four members)

-Op surely has the correct cutting disc and face shield, right?

But ok, your advice to use a grinder is Aces.

−10

Supreme-Bob t1_j6fv51h wrote

So then you'd know you should be able to flip the bike upside down and cut the bottom bracket off from the underside, right?

Yet you have no issue with the blow torch idea (grease, paint, rubber, fire, etc.)?

I'm here to give ideas and try to be helpful, not hold hands.

You have a great day now.

3

GoodGoodGoody t1_j6fvxrb wrote

I know

  • The bottom bracket, pedal arms and wheel are in the way, even from underneath

  • even if you remove the wheel the irregular shape of the bottom half of the kickstand makes grinding difficult and will lead to skipping the disc in inexperienced hands

I’ve done this exact repair several times. You haven’t a clue what you’re talking about or how to do this repair efficiently, safely, or without risk of collateral damage.

Further, not sure where you got the dumb idea that I agree with the torch idea. If you could read I actually said it was unnecessary.

Have a great day yourself.

−10