Submitted by everybanana t3_10ogc49 in DIY
Rubix321 t1_j6f0vaz wrote
Reply to comment by everybanana in Whole house humidifier keeps leaking by everybanana
I'm betting that it's getting sitting on the drain... Looks like it has a little valley in it that should let water through from the sides, but I bet it's covering up the hole now.
If it were mine, I'd probably find something flat and plastic to prop it up a bit on either side to let the water under it better.
It's just going out into the drain, I wouldn't think it would need to be filtered at that point.
everybanana OP t1_j6f1yjd wrote
It drains into a condensate pump which then pumps it into the drain. I'm thinking the cloth is there to help prevent the pump from building up a bunch of stuff. I had the same idea about using plastic shortly after making this post. I 3d printed a 2mm thick plastic thing that clipped onto the bottom to raise it up slightly. So far it seems to be working fine.
Rubix321 t1_j6f2cid wrote
Ah okay, mine drains straight down into a drain in the floor (via gravity).
I thought about how 3d printing could help, but not everyone has access to such goods yet so I didn't mention it.
Hope it works!
Viewing a single comment thread. View all comments