Viewing a single comment thread. View all comments

Apprehensive-Egg374 OP t1_j5wnng4 wrote

Reply to comment by furgurburgur in How can I add a second 1/4 inch water line to under my kitchen sink? by Apprehensive-Egg374

Thank you! This gets attached to the 1/4 end of the Tee I already have right? And then I attach the two water lines I want to add to the shark bite tee?

1

Resolution_69 t1_j5wr1wb wrote

You'd snip the white 1/4" line a couple inches in from the other tee and install the 1/4" tee there.

Edit: or a couple feet in. It really doesn't matter where you tee

2

Apprehensive-Egg374 OP t1_j5ww6nw wrote

Oh I see. I’m using a stainless steel hose for the fridge line. So I don’t think I would be able to attach that to this tee. I’d need a compression tee. Any ideas?

Is there a reason that I can’t connect another brass tee on top of the first tee?

1

Resolution_69 t1_j5x23pt wrote

You can put another brass tee on top of the other one

2

Apprehensive-Egg374 OP t1_j60annk wrote

Hey, I have another question. I’m hearing the water line pipes may not be suitable for water. What do you think?

Here are some better pictures of the pIpes:

https://imgur.com/a/YotJUGx

Do you have any advice based on these pictures? Like does the pipe need to be removed? Or is it fine as is? If it should be replaced, what do you think I should use to replace it with?

1

Resolution_69 t1_j61r19s wrote

I'm not sure if you want to replumb your house, but old brass fittings had lead in them. Newer lead free ones have markings to identify them. Learn more about that here

1

Apprehensive-Egg374 OP t1_j63w18c wrote

Thank you so so much!!

Do you think it would be possible to setup a washing machine to get hot/cold water and drain to under the kitchen sink?

1

Resolution_69 t1_j63xay2 wrote

People do that with dishwashers all the time, yeah.

Clothes washer, idk. They have a pretty high discharge rate. I've never seen it under a sink like your dishwasher is.

1

RandomAverages t1_j5xagku wrote

Sure you can stack them. They have a washer on the one end.

1

Apprehensive-Egg374 OP t1_j5yl73i wrote

Thx! I’m also gonna take the bottom Tee for the dishwasher and move it to the hot water side. Once I take the tee out, how do I put the pipe back into the bottom shutter valve? Do I just put Teflon tape on the pipe and then push it into the shutter valve?

1