Submitted by studmaster636 t3_10ghldk in DIY
real_b_man t1_j52ribk wrote
Your strike plate is too far forward. Move it back a quarter inch, you may need to drill/chisel into the jamb to allow for the bolt to seat into the strike plate hole properly
studmaster636 OP t1_j52rrj7 wrote
Thanks for the reply. That would still be the case if the bottom of the door was more flush?
real_b_man t1_j52tb19 wrote
Something is out of plumb then. Compare plumb of both sides of jamb.
studmaster636 OP t1_j52w3t0 wrote
My level is showing plump on each side inside the frame and in the face. Any thoughts on where would be off with this kind of issue?
real_b_man t1_j52xvxo wrote
Top or bottom hinge might be set too far forward or back.
Viewing a single comment thread. View all comments