Comments

You must log in or register to comment.

ObligatoryOption t1_j6jq4dv wrote

Don't trim it, move it out a little bit. If you trim it, you might chip the finish or end up with an uneven edge that will bug you for years. But if you pull out the dishwasher to see how the side panel is attached to the countertop then you may be able to unscrew a couple of brackets, move the top just 1/8" and screw it back. There's a good chance this will be enough and you won't have to also move the bottom. But if you need to, then pull out the quarter rounds, try to gently tap the bottom to move that out as well; it might just move enough to give you the clearance you need.

7

TARacerX t1_j6jxqfi wrote

Use a router bit. Will make a nice edge.

2

danauns t1_j6kxw5v wrote

Dishwashers don't get installed in cabinets, they get installed into 24" gaps between cabinets. Or in your case, a panel is installed to support the hanging end of the counter creating the same 24" cavity for the dishwasher.

How wide is your cavity? The correct answer, is to move that outside panel so that your dishwasher fits properly.

2