Viewing a single comment thread. View all comments

Joecool2008 t1_j6565ft wrote

If you seal the bays with plastic, you could do blow in insulation.

0

Blackking203 OP t1_j656tbf wrote

I'm not opposed to it, but that does sound a bit complicated and expensive. I'm looking to see if I can insulate this 1 wall for about $100 or less

−1

Joecool2008 t1_j6576m2 wrote

Insulation is hard to do nowadays less than a 100. Might get foam board and cut it down.

2

Blackking203 OP t1_j657wvf wrote

I was thinking about that too

1

Joecool2008 t1_j659nux wrote

A serrated knife cuts it well. Or, Home Depot has some pink board with perforated lines to allow for easy sections.

2

Blackking203 OP t1_j674qss wrote

I've been pricing things out and you are right. I think I'm going to do rigid foam and just cut it to size around the framing and used spray foam for any gaps.. I have about 88 sq. ft and the price is around $224 for 2in....What do you think about 1 1/2 inch?

1

WISteven t1_j68fzl5 wrote

Make sure you cut the insulation about 1/4" short on all sides. That will leave a nice gap to fit the spray foam in.

2

Joecool2008 t1_j6753mp wrote

Since I don't know the temperatures around your parts, I would be looking at the R values. But, 1 1/2 board does a decent job.

1