Viewing a single comment thread. View all comments

BeyondRemarkable t1_ja2uc55 wrote

Have you considered using a brush and just going slow and careful between the switches? You can always mask off the switches to get the spray finish on the areas that will be exposed. Once the key caps go back on the inner area will be barely visible so a brush finish could be sufficient to accomplish your goals.

1

ez2knockbeats OP t1_ja3kh63 wrote

Not a bad idea. I think if all else fails then I will go with that. Thank you. Do you know what type of brush paint would be best for this metal?

1