Submitted by ez2knockbeats t3_11c9j86 in DIY
Sevulturus t1_ja38qo8 wrote
Take the case apart and paint it. The switches will be soldered to the circuit board that is held between the two pieces of the case. Just disassemble it more.
I can even see the small silver screws you need to undo in order to take it apart. Take all of those out.
ez2knockbeats OP t1_ja3k7ko wrote
So I opened it up and the circuit board seems attached to the top because the switches look like they were pushed through from the front and then soldered to the board and this lip (in attached picture) keeps them from being pushed through to the back
Sevulturus t1_ja3oz3n wrote
That is shittttttty.
Good luck I guess.
ez2knockbeats OP t1_ja3r4of wrote
😂😂 thank you
Viewing a single comment thread. View all comments