Viewing a single comment thread. View all comments

VitalianBeef t1_j8esixx wrote

If it looks anything like the kohler one it will look like this. https://www.kullysupply.com/kohler-gp77759-mixer-cap the little set screw attached to the red part is what I’m referring to. It helps adjust the hot water side so it’s not too hot.

1

Apprehensive-Egg374 OP t1_j8eus3d wrote

Ahh I understand. So do I loosen that screw or take it out?

1

VitalianBeef t1_j8f4v1r wrote

U would screw it further into the red piece. That will allow the handle to spin a little further—up to that red piece / set screw. If that makes any sense.

1