Viewing a single comment thread. View all comments

bushidopirate t1_j8eow1l wrote

Reply to comment by Bearality in unable to remove overflow plate as its stuck. How do I remove the lever? by Bearality

I had the same problem when I replaced mine 2 months ago. I’m also the least handy person I know, so I was convinced I was doing something wrong.

It turns out, the angle you need to pull it out is kind of tricky. When I finally got the angle I needed after jostling it around for a few minutes, it came out surprisingly easily. Don’t pull too hard, but wiggle it side-to-side or up-and-down a tiny bit as you pull.

4

Bearality OP t1_j8eqrge wrote

Should i be squeezing both bars together or just wiggle it?

2

bushidopirate t1_j8erhub wrote

Just wiggling is fine. If you need to, you can use a pliers to squeeze that little pin that connects the two bars and remove the pin to take off the faceplate, but it shouldn’t be necessary. It might give you a bit more wiggle room.

4