Viewing a single comment thread. View all comments

Sqwill t1_ivpy4o5 wrote

Reply to comment by Donotaskmedontellme in 3D-printed weapons: Interpol and defense experts warn of ‘serious’ evolving threat by mossadnik

More difficult than making a gun that's for sure.

−1

gh0stwriter88 t1_ivrzr7t wrote

Depends on the ammo.... black powder or even absorbic acid based propellant isn't hard.

Its also less demanding on the weapon... but also results in a more clumsy weapon (like most BP weapons) fouling, greasing etc...

2

hidude398 t1_ivzouqc wrote

There’s a DIY smokeless project coming out this year, but also a BWA guide that talks about where to find and scavenge smokeless.

1

hidude398 t1_ivzoqul wrote

Easier, honestly.

1

Sqwill t1_ivzq8qg wrote

Not sure what’s easier than two pipes from the hardware store but ok.

1

hidude398 t1_ivzsn19 wrote

Oh, I was thinking of making something complicated like a 9mm PCC. If you’re making a pipe shotgun though, making electrically ignited black powder cartridges is dead simple.

1