Viewing a single comment thread. View all comments

KBM_KBM t1_j35r12q wrote

Do you have target labels for how much defect do you have against the flow?

1

hotspicynoodles OP t1_j35txz9 wrote

The data consists of flowrate and defect column, if there is no defect for eg. flow doesn't go above 8 lpm, then there is no default. If it does exceed then "Porosity" is mentioned with that flow rate.

1

Anjum48 t1_j38bc0o wrote

Does the data include the type of material being welded (and possibly thickness)? I think certain metals e.g. titanium, stainless, etc. may need different torch cups and therefore different flow rates

1