Comments

You must log in or register to comment.

SdoRy_ t1_j6toweu wrote

If you can, go for staebies. Not that tx rev3 are worse or anything, but r3 specifically has QC issues where the wires are often too long and lead to rattling. Also they aren't very straight most of the time.

If you need 1.2 however I would still go TX

2

DrNotHuman OP t1_j6tpue9 wrote

I was planning to use an owlabs straight wire in tx stabs how would you think this would go like is this an bad idea or what? and will the sound change since of wire swap or nah?

1

SdoRy_ t1_j6twx86 wrote

No you can do that. Don't think it will affect sound, since you basically get rid of every sound the wire could make by modding.

Have not worked with Owlab stabs though, heard they are either very good or very bad depending on the initial straightness of the wires, since it's extremely difficult to permanently straighten them if they come bent.

1

Sliced_Orange1 t1_j6treli wrote

I have used TX Rev. 3 stab kits a few times in the last few weeks and all have been good. No complaints.

2