VXQN t1_jedxlxf wrote on March 31, 2023 at 9:23 AM

Did you put the little plastic pegs in? I had issues with them being noisy at first, but putting them in sorted that right out. I've generally found them to be way, way better than other stabs, mainly because all they need is a little 205G0 and nothing else.

nicolas_33 OP t1_jedyjv0 wrote on March 31, 2023 at 9:37 AM

Yes I used those little plastic pieces. But they had a snug fit in the PCB anyway.

I really don’t have a clue what was going on there. I have read a few reports from people being disappointed and people being really fond of them. That is weird. Maybe there are different batches / different tolerances for the 1.2 vs the 1.6mm variant?

MayAsWellStopLurking t1_jedz09b wrote on March 31, 2023 at 9:43 AM

What keyboard were you putting them in? Sounds like it’s a 1.6mm PCB.

Edit: if Staebies fit perfectly then your PCB is 1.6mm because I’ve not seen 1.2mm variants. So you tried putting stabilizers meant for PCBs .4mm thinner than the one you have.

nicolas_33 OP t1_jedz4s4 wrote on March 31, 2023 at 9:45 AM

Akko ACR 75 Top which has a 1.2mm PCB.

MayAsWellStopLurking t1_jedzdhz wrote on March 31, 2023 at 9:48 AM

Can you take a photo of an extra Staebies housing next to the TX one?

nicolas_33 OP t1_jedzx1g wrote on March 31, 2023 at 9:56 AM

I don’t have any extra Staebies housings left to take a picture of.

nicolas_33 OP t1_jedzeco wrote on March 31, 2023 at 9:49 AM

I put shims below the Staebies ;)