s1ckn3s5 t1_iudmc2g wrote on October 30, 2022 at 3:11 PM

very good job! to print keycaps with fdm printer is not easy I did a lot of experiments and, if it can help, I've found out the best results were printing DSA at 45° degrees (in this way both the top and the sides result silky enough)

CodeMonkeyZero OP t1_iudtcle wrote on October 30, 2022 at 4:00 PM

Did these at 0.1mm layer height. The g20 was at 0.2 I think. The corners are barely noticeable. Might try the 45° trick on the next set. Did you use supports? I ran these skirt only.

s1ckn3s5 t1_iudupda wrote on October 30, 2022 at 4:10 PM

yes supports and raft, but 0.16 layer height

https://imgur.com/a/DuDuSam

https://www.thingiverse.com/thing:5418508