CodeMonkeyZero OP t1_iudtcle wrote on October 30, 2022 at 4:00 PM

Reply to comment by s1ckn3s5 in 3d printed as much of my first keyboard as I could. Even tried sequential prints for caps with a 9/16 success rate! Grey is pla, orange is pla+. Cherry MX Reds, Knockoff pro micro w/ qmk, 128x64 oled, XDA keycaps with a single G20 for fun. Design by Joe Scotto, ScottoGame on github by CodeMonkeyZero

Did these at 0.1mm layer height. The g20 was at 0.2 I think. The corners are barely noticeable. Might try the 45° trick on the next set. Did you use supports? I ran these skirt only.

s1ckn3s5 t1_iudupda wrote on October 30, 2022 at 4:10 PM

yes supports and raft, but 0.16 layer height

https://imgur.com/a/DuDuSam

https://www.thingiverse.com/thing:5418508