Submitted by laffeybunn t3_zv0ka0 in MechanicalKeyboards
Comments
CheeseManFuu t1_j1nztd8 wrote
Yup, just had the pain of doing it manually working on my latest build (with millmax no less) and i am absolutely glad to have one starting today as well
StatusBard t1_j1odjma wrote
I could use some of those things. Are they official extras or where would I look for that?
HV_Medic t1_j1on6od wrote
Yes, they are all Hakko products and here are the part numbers:
The nozzle that comes with the FR-301 is N61-08 (it has a 1.0mm opening).
The cleaning pin for that nozzle (1.0mm) is B1087.
The drill cleaner is B1303 for 1.0mm nozzles.
The ceramic filters are A5044 (in a ten pack).
The FR-301 uses the N61 series nozzles and there are many to choose from, see Hakko's website for more, but the N61-08 is probably the most popular.
So far, I've gotten all of these parts from Amazon, but I'm sure there are plenty of other vendors that have them including from Hakko directly.
shugix t1_j1opl2j wrote
I would recommend getting a 888-001 Cleaning Drill. I found it quite useful the times mine got clogged. Most of my clogs are at the opening of the solder holder tube thing.
StatusBard t1_j1paglk wrote
Thanks!
laffeybunn OP t1_j1s35kr wrote
Good to note
StatusBard t1_j1pafty wrote
Thanks!
laffeybunn OP t1_j1s340y wrote
You are a legend I'll have to buy these (I didn't buy the fr-301, too poor for that)
laffeybunn OP t1_j1s2zjf wrote
Any tips on how to use it? I've heard you just don't "use it" you have to research how to use it first. Haven't tried it yet as it's freezing outside
CorrodedRose t1_j1p8fx7 wrote
Holy moly $250? I was wondering why people use solder suckers
laffeybunn OP t1_j1ru4ue wrote
My ss-02 tip broke almost immediately and replacements are stupid expensive.
HV_Medic t1_j1nna5f wrote
Lovely tool, I wish I had bought one much sooner than I did. Would have saved so much time that I spent desoldering with braid and cheap solder suckers, it made projects that used to take an entire afternoon of work take 15 minutes. My advice though would be to get extra tips, cleaning pins, and ceramic filters. Depending on how much rework you do, you could go through them like water. Also, the little mini drill in a pin vise that Hakko sells is useful for clearing really stubborn nozzles.