Viewing a single comment thread. View all comments

shizzy0 OP t1_j6jmpp9 wrote

Reply to comment by Tweetydabirdie in Hot swap boards are terrible for travel by shizzy0

When I designed this case and poured the molten acrylic into the mud holes, I must’ve mismeasured the holes or used cm instead of inches.

6

Tweetydabirdie t1_j6jsn1t wrote

Sure, I’ll believe that… 😉

Not in any way saying an acrylic plate is a bad choice. It’s just a known issue that the switches isn’t locking. So for a keyboard you move around a lot it might not be the obvious choice.

You can get around it by machining cutouts for the locking tabs into a 3mm acrylic. I tried that once. Only once, and it was a major PITA.

4