Comments

You must log in or register to comment.

grimm343 t1_j5gldvy wrote

Nice, and congrats on your first!

1

Hootinnanny87 t1_j5hmhyg wrote

Looks awesome I can’t wait to receive mine. Are those the caps that it came with? I’m just looking at the bottom left ctrl and it just appears too small? Might just be me. Either way! Awesome job

2

Hootinnanny87 t1_j5i08yc wrote

Ah okay, good to know, I was a little concerned for when I receive mine. But knowing it’s an asthmatic choice makes me feel better. How do you like typing on it? I just received my melgeek pixel and it’s tough to type on.

2

grimm343 t1_j5i3q91 wrote

Haha, I'm glad it was all straightened out /j

I ended up on GeekHack my first time thinking I damaged a trace since seven keys suddenly wouldn't work after soldering. Turns out I either overtightened the screw-in stabilizers or caused a short since I was using squares of electrical tape rather than fiber washers for insulation.

Hope you really enjoy yours!

2

trashman942 t1_j5ib232 wrote

I was looking at this kit too, how’re you liking it? Also, are they Lego copy pieces? Like would swapping out pieces for other colors work on the case?

2

fffffffuuuuuuuuug t1_j5izbl1 wrote

Every time I see this kit, I just think that (please don't kill me) it looks super easy to build one with gaskets in mind.

But then I remember that I can't build anything with Legos unless I have an instruction book...

1

SlashdotDiggReddit t1_j5ymrnz wrote

I just finished building mine, and I have a few ... "problem" switches, meaning it takes way too much pressure to activate. Did you experience this at all?

2

Clarkthebarista t1_j67wdqz wrote

I'm thinking of buying this board soon, did this require any programming at all or was it 'plug and play'?

1

Hootinnanny87 t1_j6ct0x2 wrote

Yeah, I tore the board apart and got down to the pcb and switches being mounted together. I literally picked it up. And pressed each switch into the pcb to seat it. It’s perfect now you do need to confirm each switch is fully inserted into the pcb, good luck!

1

SlashdotDiggReddit t1_j6jh4bd wrote

No, I have not, and I am getting a little annoyed. Take a look at THIS. I contacted their support and they replied one time last week with:

> "Can you try to adjust the metal contact to allow the pin inserting?"

Which I tried a little but cannot without damaging the board ... I believe. I have email'd them three times since their initial response and they have not responded to me. At this point, I am going to start advising against ordering from KBDcraft.

1

Hootinnanny87 t1_j6k0wb5 wrote

I’m sorry to hear, mine was simply pressing the contacts in further. I will say I am very disappointed as I didn’t get the brick that is supposed to be under the usb cord and they responded by saying they knew that kits were missing it but it was fine. So now I need to pay to source one brick because they don’t care, very disappointing.

1