Submitted by Initial-Street-8689 t3_yahnzq in headphones

Moondrop Kato Steel Nozzle Now ur probably wondering how I ended up in this situation, long story short, im stupid. With that being said, i am asking for your help to see if i can do anything or just, buy a new pair of nozzles for my iem.

24

Comments

You must log in or register to comment.

ReaLx3m t1_itbv1x1 wrote

Cant see very clearly whats the damage on the nozlle, cant you just glue the filters back in?

If you messed up the glue, then just get new nozzles from moondrop if you want the same tuning. Or get some different density(100/200/300/400/500) nozzle filters and/or some steel mesh screens and play around, you might arrive to something that you would like even better than the stock nozzles tuning.

4

Initial-Street-8689 OP t1_itc0v72 wrote

Tried to clean the nozzles with q tip and isopropyl alcohol to which i probably had exert too much force and alcohol which messed up the adhesive and filters. Unfortunately, i dont have much experience regarding iems, and i got these secondhand. No worries tho, i already ordered a new pair of nozzles for 8 usd/500php. Thanks for ur suggestion about trying different filters but i dont think im experienced enough to place them on the nozzles but i would probably try them in the future as i dont like too much treble on the iems.

1

ReaLx3m t1_itc3goq wrote

> i dont think im experienced enough to place them on the nozzles

Its pretty trivial, filters have the adhesive applied in a cirlce shape on the edges, you just stick them on the inside ledge of the nozzle holding them on a needle tip or with tweezers. You just need to make sure to measure the nozzle size so you get the right size filters, nothing more to it. To remove just use a needle and go around the edges and try to stick it underneath, then just peel.

And would probably benefit you, since you say you dont like treble and they do affect mostly upper mids/treble.

Heres an example of the effect they have, it 200 on top going down to 500 filter. 200 is pretty close to just steel mesh(screen door like filter), and 100 would probably be like no filter at all, though havent measured that one. https://imgur.com/FPDYflL

And now you have some spare nozzles to experiment with :).

For more bass plug the vent near the nozzle, you can use micropore tape(found in pharmacies) or even better try different density filters there to control the ammount of bass, and to reduce bass plug the vent farther from the nozzle.

Edit: This is not a kato measurement in the example, so dont know what is the starting point/effect the kato stock nozzles/filters have on the sound signature.

2

Hyurakun t1_ite6i3i wrote

Never, never and I mean NEVER!! clean IEMs with alcohol, alcohol is a solvent and could damage the paint and/or the glue, I know you want to have clean your IEMs but alcohol is too strong better use some baby tissues or a degreaser for oily skin, at the end of the day that's the only thing you should clean your IEMs from.

You could try to re apply it to the nozzle but if you already ordered a new pair I don't know how much do you want to have 2 pairs of each filter.

1

entivoo t1_itb6unj wrote

buy something better, preferably not made in china

−24