Viewing a single comment thread. View all comments

icanseeyourpantsuu OP t1_ixjkob4 wrote

Reply to comment by WoodenSporkAudio in 100Ω output impedance by icanseeyourpantsuu

Man, thanks for the reply but sorry i dont understand.

I made this post because a guy on youtube said that the 600ohm dt880s does not need more than 100mW @600ohm and that it's more on output impedance matching where the 880s require a 100ohm output impedance match.

So im looking for Amps that has this specification or would closely perform like it. So far, i only found the Bottlehead Crack which is rated 120ohms of output impedance, but it's at 349usd. I'd like to keep my budget under 250.

1

WoodenSporkAudio t1_ixkk84l wrote

Is DT880 600 ohm with 100 ohm an industry thing?

If so, Then get an amp with around 7.75+ volts into 600 ohms with a 100 ohm OI

That’s approx 100mw into 600 ohms raw RMS without the complex impedance curve of the headphone and the interaction with the OI of the amp

You can drive high impedance headphones with low Ouput Impedance amps but the higher output impedance options are like a nice analog EQ very tasteful sometimes

1