Viewing a single comment thread. View all comments

redsandrevolt OP t1_ixyr977 wrote

Reply to comment by ryrypizza in Plunge router or drill press needed by redsandrevolt

I checked Home Depot, Lowe’s, and other places around as I need one set of 16 to be 1/16” and the other set to be 6/16”.

1

ryrypizza t1_ixysame wrote

Gotcha. Other than a maker space, I would look up drill guides. There are some pretty inexpensive options. And a plunge router will not be good for 1/16 holes.

As a carpenter who owns a plunge router, but not a drill press; if I needed to make 32 holes I would make a wooden guide from scrap, with the proper hole-spacing/layout, and use that to transfer the holes to your finished.

Good luck

1