Viewing a single comment thread. View all comments

GeoGeoGeoGeo OP t1_iyljqrw wrote

>Possibly the risk of causing an eruption

How would it cause an eruption (especially considering it can't erupt because its only up to 20% melt fraction)?

4

kinda_alone t1_iyn7z7l wrote

Geothermal tapping cannot cause an eruption.

1

bladow5990 t1_iynyjx8 wrote

It did at fly geyser in NV

−1

GeoGeoGeoGeo OP t1_iyo4pyd wrote

To be clear, we're talking about an eruption of magma not hot water out of a cm scale borehole.

3

SirRockalotTDS t1_iyn5hhe wrote

Now you'll have to explain to me why it CAN'T wrrupt.

A lot of that solid is well over the melt temperature and could instantly turn into melt if the pressure was suddenly reduced. How are you sure that that wont happen?

−3

GeoGeoGeoGeo OP t1_iyo1hxi wrote

People have drilled directly into magma before (Hawaii in 2007? & Iceland 2009), and there has been no eruption for a couple of reasons:

(1) drill holes are too narrow to transmit the explosive force of a volcanic eruption. (It’s the equivalent of piercing a champagne cork with a pin rather than removing the entire cork at once.)

(2) Due to the small diameter of drill holes (typically <10 cm), the small amount of magma that could flow into the shaft would solidify long before reaching the surface

See Iceland Deep Drilling Project:The first well, IDDP-1, drilled into Magma for more information.

5

Strontium90_ t1_iylomn5 wrote

you're just using the steam to drive the turbine, cause eruption how?

3