With only one power line in. The easiest way is to buy a universal remote . you will be able to turn on & off both. They run About 30-50 bucks and of course some wiring at the fan support box

Sorry man dolly and a bunch of guys

Might be filled with calcium crack that drain off

The attic has to breath or it will get hotter, and so the main house. Vents low and vents high passive cooling. The foam just slows the progression

That opening undoubtedly has 2x framing inside predrill into that sink screws bolts whatever into it vertically or horizontally by min 2” you are done it with hold you up

Silicone will start drying before you finish applying, tape will pull it off more the longer you wait. I don’t use tape My choice 1 -That needs to be cleared out first. 2-You can use a silicone grout that matches the existing grout or Try Amp caulking very little sag. Just a simple reminder there’s a 1/4-1/2 “ lip extending upward on that tub you can’t see. Curious if that sub floor is sagging

Four paw

Lost a leg?

Was it completely sanded to begin with?Sanded between coats with what grit? #400 would be plenty What is the wood species? Maple?

The door handle has some integral flush bolts that latch in the center of the jamb. My guess is that when it was pushed downward it revolved too far. The post on taking the hinge pins out is the best bet then figure out how to release the latches once it’s off

You used a stud finder so you are on the wood guessing you didn’t predrill and studs split. It doesn’t take much to split fir.

Maybe it’s sheet foam pink and white? Wont hold nails semi hard or stiff but able to push in make dents? If it is drywall a big box of paste is 10 bucks large drywall blade same. Id get a hawk or trough to get the mud on the blade well. Try you hand at laying on new drywall paste flat.

That’s a slap

Its behind the vanity?

Ditto what this guy said open up the plastic vent pull it back doorway windows

Exactly

Ditto what he said, unless you are prepared to go all the way( isn’t all plumbing like this?) can you get to the back side of the plumbing?

Ghosts ? How is the jack moving up ? The door never does this when opening or closing? Its the floor or subfloor weight pushing it down

Thats cheap 5 k to remove exterior back yard pad and dig down replace cast with ABS added bull horns maybe 20ft

Get rid of the cats better idea

Unless you are used to doing this id advise against that. Some older homes are aluminum wiring. You need to add certain wire nuts as well as looking for burnt wires.

Dont slice/cut the wire with screwdriver

Mechanical fasteners through a larger piece of wood strip would clamp it in place. The leather would remain as your hinge. Dare to say look a tad better too.

One of those motorized Black and decker turkey knife cutters or hot knife. Hot knife reduces the size as it melts.