CodeMonkeyZero

CodeMonkeyZero OP t1_iue8a1l wrote

Reply to comment by RiboNucleic85 in 3d printed as much of my first keyboard as I could. Even tried sequential prints for caps with a 9/16 success rate! Grey is pla, orange is pla+. Cherry MX Reds, Knockoff pro micro w/ qmk, 128x64 oled, XDA keycaps with a single G20 for fun. Design by Joe Scotto, ScottoGame on github by CodeMonkeyZero

They are pla with a little texture. Considering making the XDA model completely flat so I can iron them.

1

CodeMonkeyZero OP t1_iue829o wrote

Reply to comment by pabloescobyte in 3d printed as much of my first keyboard as I could. Even tried sequential prints for caps with a 9/16 success rate! Grey is pla, orange is pla+. Cherry MX Reds, Knockoff pro micro w/ qmk, 128x64 oled, XDA keycaps with a single G20 for fun. Design by Joe Scotto, ScottoGame on github by CodeMonkeyZero

The 2u need to be reprinted with stabilizer stems. Also since stems have some pretty fine detail they aren't all perfect, had some stringing that needed cleaning up, but the keys are pretty solid on the switches.

2

CodeMonkeyZero OP t1_iudtcle wrote

Reply to comment by s1ckn3s5 in 3d printed as much of my first keyboard as I could. Even tried sequential prints for caps with a 9/16 success rate! Grey is pla, orange is pla+. Cherry MX Reds, Knockoff pro micro w/ qmk, 128x64 oled, XDA keycaps with a single G20 for fun. Design by Joe Scotto, ScottoGame on github by CodeMonkeyZero

Did these at 0.1mm layer height. The g20 was at 0.2 I think. The corners are barely noticeable. Might try the 45° trick on the next set. Did you use supports? I ran these skirt only.

4

CodeMonkeyZero OP t1_iudh5vy wrote

Reply to 3d printed as much of my first keyboard as I could. Even tried sequential prints for caps with a 9/16 success rate! Grey is pla, orange is pla+. Cherry MX Reds, Knockoff pro micro w/ qmk, 128x64 oled, XDA keycaps with a single G20 for fun. Design by Joe Scotto, ScottoGame on github by CodeMonkeyZero

Also modded the files to use M2.5 screws since I didnt have any M2s. Oled face plate also needed adjusting to fit a slightly different mounting profile and take M2.5 heat set inserts.

2