Dildo5000
Dildo5000 t1_iugtuq8 wrote
Reply to comment by Zenit_IIfx in Mortar for installing Schluter Ditra to concrete with vinyl flooring glue still mostly present? by Zenit_IIfx
You realize you need to level your floor right. Not only do you need to remove the glue. Grind and scratch your concrete. But is very, very, very likely not flat enough for tile. Which means you’ll be pouring an SLC over your freshly ground concrete floor.
Do it right and don’t be a hack.
Also you need to pull your toilet off. Sink cabinet. And baseboards.
Dildo5000 t1_itkhpqt wrote
Reply to comment by LowHat5830 in Drywall beneath screw locations is bulging. What could be causing this? by LowHat5830
No. The bulge is a broken patch of drywall. Put new screws below it into the studs on a non fucked area of drywall as 2 inches for the edge of the bulge. And cut the bulge out. Then patch the hole with a piece of drywall, mud, and drywall tape.
Dildo5000 t1_j17vvvw wrote
Reply to Underfloor heating - can you warm up the floor only? by FatFart777
Ditra heat.