Iamnotericforeman t1_ja0u5wz wrote on February 26, 2023 at 12:16 AM

Reply to How do I proceed with wiring. I'm planning on converting a ceilng fan into led potlights room. is my switch single pole? can I use my old ceiling fan wire for pot lights? by _Deathless

Did the fan have a separate switch for the light and one for the fan?

Iamnotericforeman t1_j9zqzj2 wrote on February 25, 2023 at 7:36 PM

Reply to comment by Few-Opinion5223 in Painting; Sanding walls before adding a new layer of paint by simon_chess123

Use a pole sander. It will make it easier for walls. There always seem to be some rou spots that you’ll notice after you paint if you don’t sand.

Pole sander is not a person from Poland who does the work for you!

Iamnotericforeman t1_iu6whvn wrote on October 29, 2022 at 12:33 AM

Reply to How do I replace a built-in halogenic lamp with an LED? by ostrodis

Turn off the light switch .

Remove the springs at the light. This should allow you to remove the bulb from the housing.

Unplug the bulb from the base. The bulb probably either 2 small metal pins in the back or a bayonet base. To release the bayonet base push the bulb toward the base. The 2 pin base just pulls straight out.

Take the bulb to the hardware store and see if you can find something similar. For an LED between 2700k and 3000k that’s the warm range for colors.

I gave this in baby steps to help you know what you’re getting into. I’m not insulting your intelligence.

Good luck