bobblehead230

bobblehead230 OP t1_jdxi32e wrote

Reply to comment by Eclipsetube in iPhone 13 Pro Overheating? - Is this a potential fire hazard? Info in comments by bobblehead230

That was a good idea. I took a look at it and I have honestly never paid attention to this, but it is very peculiar that the battery went to 0% about the time that I remember plugging it in and back up when I did the reboot

https://preview.redd.it/mnjnl6xcfeqa1.jpeg?width=1170&format=pjpg&auto=webp&v=enabled&s=6e92a44f8f0445c0abdd94415420612afdd3469f

Edit: iOS 16.3.1 btw

1

bobblehead230 OP t1_jdxhdpm wrote

Reply to comment by 87MS in iPhone 13 Pro Overheating? - Is this a potential fire hazard? Info in comments by bobblehead230

Sorry I should have been clearer, the bulge is in the silicon protective case, like as if got hot and warped. That would be crazy if I had a bulge in the actual aluminum frame, I wouldn’t feel comfortable turning it on at that point.

https://preview.redd.it/9u5tk8vgeeqa1.jpeg?width=3024&format=pjpg&auto=webp&v=enabled&s=5e1da9cd0e6447a61868869fbdfedf35a0b7260a

1

bobblehead230 OP t1_jdvsq86 wrote

Reply to iPhone 13 Pro Overheating? - Is this a potential fire hazard? Info in comments by bobblehead230

IPhone 13 Pro, about 1.5 years old. I woke up this morning to an iPhone that was connected to the charger, but unresponsive. It was left on the charger from when I went to sleep (about 1am) until I woke up (about 6am) which is the charging routine that I have used with every phone that I have had. I was able to reboot the phone by following these steps:

  1. Press and quickly release the volume up button.

  2. Press and quickly release the volume down button.

  3. Press and hold the side button until you see the Apple logo.

After reboot, phone is behaving as expected, but then I noticed the bulge in the side of the case where the volume buttons are. It is quite pronounced and I am not sure if the pictures truly do justice to the amount of bulge. I am going to go out on a limb here and assume that the phone got extremely hot last night while charging and that’s why it was unresponsive this morning and the cause of the bulge? Has anyone had any experience with this or maybe can correct me if I am wrong? I am concerned that this is going to result in some sort of catastrophic failure. I charge via a third party cable and a usb adapter that is built in to my nightstand. I am going to change this immediately and use an apple cable/usb adapter, but could there be any other cause? Also, my Nintendo switch is on the same usb adapter and is completely normal this morning.

1